• Maximized arm speed by selecting high or low pressure cylinders which correspond to operating pressure of lift truck.
  • Thin arm profile enables damage-free “knifing” between tightly stacked rolls.
  • Split left hand arm allows handling rolls with up to a 75 mm difference in diameter.
  • Full width lip over UHMW bearings provide maximum strength and bearing support. Greatly reduces wear on bearing surface and the need to frequently replace bearings.
  • Hydraulic circuit provides the following:

  • - Over-clamping protection
    - Sideshift pressure relief
    - Excellent accessibility for servicing
  • Great visibility.
  • Built-in stand to easily remove and store clamp when not in use.

  • Non-split arms on both sides for one or two roll handling.
  • HFC (Hydraulic Force Control).
  • AFC (Adaptive Force Control).
  • Rubber pads for optimizing clamp force.